Wilmington Auto Repair

Sure, winter is quickly fading in the rearview mirror, but the peril of icy roads is replaced with a whole new set of driving challenges in spring. Deer and other wildlife. You are not the only one who gets spring fever.  Animals do, too, and spring is the time they start looking for mates and food.  Be extra careful at dawn and dusk when deer are especially active.  Hitting a deer (or having them jump into your path suddenly) is a frightening experience, and even a deer/vehicle collision at slow speeds can cause injury and/or loss of life for both animal and humans, let alone expensive damage to the vehicle.  Be extra vigilant during spring. The angle of the light.  As the seasons progress, you'll notice sun angles change.  The sun is rising earlier every morning and setting later at light.  When the sun is low in the sky, that glare can render you almost completely blind.  Make sure your windows and windshield are clean; don't forget the inside ... read more

It's easy to get letters like PVC and PCV mixed up.  PVC is a plastic that's used in a lot of things, especially plumbing pipes.  And PCV is a valve that helps your engine burn off excess fumes rather than having them pollute our atmosphere.  PCV stands for positive crankcase ventilation.  When your engine ignites gasoline in the cylinders, some of the gases produced make their way into the crankcase, where oil is held to lubricate the engine.  In earlier days, those gases would be vented out through a hose and go directly into the air.  It was a waste of gasoline (since about three-fourths of the gases were unburned fuel) and a nasty source of pollution. So engineers devised a one-way valve that directed those gases back into the engine's air intake system to be burned again.  After a while, the PCV valve can get clogged up with gummy oil.  Not only does that reduce the recirculation of the gases, but it can also cause pressure in the crankcase ... read more

You probably figured out those shifty letters.  They're what you see on your automatic transmission shifter and stand for Park, Reverse, Neutral, Drive and Low.  Your automatic transmission is one of the great automotive inventions; here are some ways you can keep yours working well. Maintain your transmission regularly.  A technician will check your transmission fluid's level and even its appearance and smell.  If it's dark or has an unusual odor, that could be a sign of trouble. Change from one transmission direction gear into another only when your vehicle is stopped.  So many drivers want to switch from Reverse to Drive quickly or the other way around.  If you do that when the vehicle is moving, you can damage your automatic transmission. Keep your vehicle's cooling system in top shape.  What does the cooling system have to do with the transmission? It helps keep the transmission fluid from overheating.  Follow the manufacturer's recommendati ... read more

Did you know that having a burned out headlight can result in your rearview mirror reflecting some flashing lights? In other words, you might get pulled over by the police for only having one working headlight, because in most places it's against the law.  Not only is it illegal to drive with one headlight burned out, but it's also dangerous. You can't see down the road nearly as well at night with only one headlight, and other drivers can't see you as easily either. The good news is many newer vehicles warn you when one of your headlamps burns out. When that happens, have it taken care of as soon as you can.  While there was a time when all headlamps were pretty much the same, the same isn't true these days. There are halogen, Xenon, LED and other technologies used in modern vehicles.  Plus there are sealed beams (like those on older vehicles) and capsules. If you have a burned out headlamp, ask your service advisor for recommendations.  Usually when one side goes ... read more

Nearly every modern vehicle on the road today has power steering, a wonderful invention that makes steering take far less effort than it did in the "good old days."  Today, we take our steering for granted: until something goes wrong, that is. Most power steering these days is rack-and-pinion, the rack being a metal bar between the front wheels with notches in it and the pinion being a gear whose teeth fits into those notches.  Adding power assist makes it easy to turn. That assist comes in the form of hydraulic fluid that is pressurized by a pump powered by the engine, an electric motor that adds a power assist or a system that uses both an electric motor and hydraulic fluid. Your vehicle usually gives you a heads up that something is going wrong with its steering. Here are a few signs to look for: A humming, whirring, rubbing or grinding sound coming from you engine compartment when you turn. Signs of hydraulic fluid leaking, such as wet spots under your vehicle. The smell ... read more

If someone tells you to put the brakes on something, you know it means stop.  And stopping is one of the most important safety maneuvers you can do in any vehicle.  That means your brakes have to work properly.  Let's face it.  You stop dozens of times every time you drive.  And over time, that takes its toll on your brakes.  Friction is what stops your vehicle.  Most newer vehicles have disc brakes, and the parts that wear out the fastest are those that rub against each other every time you stop, the rotors and the pads. The rotors are discs that rotate with the wheels, and the pads are removable surfaces that make contact with the rotors to slow or stop your vehicle.  Bits of both wear off each time you stop, and when enough of either (or both) lose too much material, your brakes become unable to safely slow or stop your vehicle.  The pads usually are the parts that wear out first.  Signs that your brakes might be getting worn are: Y ... read more

When you head down a straight road, does your vehicle pull to one side?  Do you feel vibration in any of the wheels? If you've noticed any of these things, it's probably time for you to get your wheel alignment checked. When your vehicle left the factory, its wheels were parallel to each other and perpendicular to the ground.  That maximizes traction for good steering and braking. Every time you take your vehicle on the road, normal wear and tear will affect your alignment. Hit a bump, a pothole or a curb and all those little knocks will add up Bad alignment not only can cause your steering wheel to pull unevenly, it can also wear your tires out a lot faster than they should. In fact, if you look at your tires and see one side of the tread is a lot smoother than the other, it could be another sign of bad alignment. Since different problems can cause similar symptoms, the first thing our trained technician will do is test drive your vehicle. Then, they'll check the front end a ... read more

No matter what the weather is like outside, your internal combustion engine expects to keep its cool all the time, even when it's really cold.  That's because engines create the power that moves you to your destination by a series of tiny explosions of a fuel and air mixture. In turn, that generates a lot of heat in a small space. Your vehicle has a complete cooling system with a lot of different parts that work together to keep the temperature at a point where the metal engine parts won't heat up enough to warp.  Its lifeblood is coolant, a liquid that circulates through the engine (and, in most vehicles, the transmission, too) through a series of hoses and tubes.  In order to get rid of the coolant's heat, your vehicle has a part you probably recognize: the radiator.  It does what its name proclaims: radiates heat.  The radiator has a series of thin metal fins that coolant goes through, and when outside air passes over them, the heat is dissipated from the ra ... read more

Keeping your vehicle's brakes in top shape is one of the most important things you can do for your safety and those on the road with you. Most drivers know a little about brake pads and rotors but maybe not so much about another brake component called the calipers. Disc brakes work by a mechanical system that presses your brake pads against discs called rotors (you can usually see these discs through your wheels). The friction stops your vehicle smoothly when everything is working the way it should.  The calipers use the hydraulic pressure of the brake fluid to apply the stopping power.  After they've been on your vehicle for a while, the calipers can get stuck or wear out.  If calipers on one side of the vehicle work correctly and not on the other, you might feel a pull in one direction.  You might feel the same kind of pull if the caliper is stuck and is applying constant pressure.  You might hear scraping or squealing coming from a stuck caliper and you migh ... read more

When you hear hissing sounds coming from your vehicle, you might start thinking the worst.   One type of hissing coming from around your air conditioner may be a normal sound, or it could be a sign of serious trouble. First - the normal sound.  When you turn off your vehicle, the refrigerant goes from its high-pressure side to the low-pressure side. Some of those noises are normal.  But when it hisses all the time, that's another story. One cause could be that the refrigerant is leaking.  Air conditioners are fairly complex systems that involve various pumps, hoses, valves and motors.  When your air conditioner is cooling, the refrigerant changes from a gas to a liquid and back.  That refrigerant is under pressure, and there are many places it can leak from.  A hissing sound can also be a failed valve in your air conditioner's compressor.  It is what controls the refrigerant's pressurization.  It's important to have this fixed fairly qu ... read more